Skip to content
Appointment timing depends on ZIP code, route capacity, and access.
Call (310) 554-8899
Kenmore appliance service
Error Code

Kenmore Range F017 Error Code

Plain-language guidance for Kenmore code F017 on Range — symptoms, safe checks, and when to call a technician.

Book a Repair (310) 554-8899
  • Upfront Estimates
  • Approval Before Repair
  • Expert Technicians
  • Workmanship Warranty

At a glance

Error code overview

A plain-language snapshot of F017 for Kenmore Range — confirm the model series before you act.

Lena Hart Written by Lena Hart Appliance Repair Content Specialist Published October 20, 2026

Content status Verified

Error code F017
Appliance Range
Quick answer

Kenmore range F017: the user interface board cannot configure the touch panel. See the reset and harness steps from the manual.

Model compatibility

Kenmore reuses codes across series and model years, so F017 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

User interface board is unable to configure the touch panel.

F017 tells you the user interface board is unable to configure the touch panel. Kenmore documents it for 790 freestanding ranges and Elite electric slide-ins (790.4131, 790.4255, 790.5256).

Manual sequence

  1. Power cycle: disconnect, wait 30 seconds, reconnect.
  2. Code back? Disconnect power and inspect the wire harness connections between the touch panel and the user interface control board. Loose wires get reconnected; a damaged harness gets replaced.
  3. Replaced the board or the panel recently? The wrong part may be installed, so match the part number to your range model number.
  4. No part replaced and connections okay: the user interface control board is replaced.
  5. Problem still there: the touch panel is replaced.

On the Elite slide-in these parts are the oven user interface control board and the touch control panel.

Related codes

  • F012 (mismatch after a wrong replacement part)
  • F015 (touch panel failure)
  • F013 (user interface control board failure)

Kenmore range repair in Los Angeles

Kenmore range owners in Los Angeles can reach us at (310) 554-8899. The Kenmore range service page covers the appliance. Have the code, the model number and anything you already tried ready when you call.

Source: Sears PartsDirect – 790 model 4-digit range error codes; Sears PartsDirect – Elite 790 electric slide-in range 4-digit error codes

Caution

Safety warning

Important safety warning

Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Get started

Seeing this code on your Kenmore appliance?

Book a specialist Kenmore service visit for a clear estimate and approval before any repair. Experienced technicians, clear diagnostics, and workmanship coverage on completed repairs.

Book a Repair (310) 554-8899
Service areas

Available in these areas

Get started

Ready to restore your Kenmore appliance?

Book a repair online or call us — clear estimates, approval before any work, and a workmanship warranty on completed repairs.

Book a Repair (310) 554-8899

Book a repair

Tell us about your Kenmore we’ll take it from there

Share your model, symptom, and ZIP in Los Angeles County or Orange County and we’ll confirm an appointment. Prefer to talk? Call us during business hours.

(310) 554-8899
Phone (310) 554-8899
Email info@kenmorelosangeles.support
Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Kenmore appliance repair across Los Angeles County and Orange County.
Response time Appointment timing depends on ZIP code, route capacity, and access.