Skip to content
Appointment timing depends on ZIP code, route capacity, and access.
Call (310) 554-8899
Kenmore appliance service
Error Code

Kenmore Wall Oven F3/E0 Error Code

Plain-language guidance for Kenmore code F3/E0 on Wall Oven — symptoms, safe checks, and when to call a technician.

Book a Repair (310) 554-8899
  • Upfront Estimates
  • Approval Before Repair
  • Expert Technicians
  • Workmanship Warranty

At a glance

Error code overview

A plain-language snapshot of F3/E0 for Kenmore Wall Oven — confirm the model series before you act.

Lena Hart Written by Lena Hart Appliance Repair Content Specialist Published October 20, 2026

Content status Verified

Error code F3/E0
Appliance Wall Oven
Quick answer

Kenmore 665 wall oven code F3/E0: defective temperature sensor or an open sensor circuit, with manual steps.

Model compatibility

Kenmore reuses codes across series and model years, so F3/E0 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Defective oven temperature sensor or open oven temperature sensor circuit.

A Kenmore 665 model wall oven shows F3/E0 for a defective oven temperature sensor or an open oven temperature sensor circuit.

Steps in the manual

  1. Disconnect power or unplug the wall oven.
  2. Reconnect the oven temperature sensor wire harness connection if it is loose.
  3. Replace the wire harness if it is damaged.

Technician-side checks

A technician measures the sensor’s resistance with a volt/ohm meter. The sensor is replaced when it does not read 1080 ohms at room temperature (70 degrees F). When the sensor and harness connections check out, the electronic oven control (EOC) is replaced.

Nearby codes

The shorted version of this fault is F3/E1. Excess heat readings are F3/E2 for Bake mode and F3/E3 for Clean mode.

Los Angeles wall oven service

Seeing F3/E0 on a Kenmore wall oven? Oven repair in Los Angeles is a call to (310) 554-8899 away. Tell them the code, the model number and whether the harness connection was loose.

Source: Kenmore 665 model wall oven error codes

Caution

Safety warning

Important safety warning

Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Get started

Seeing this code on your Kenmore appliance?

Book a specialist Kenmore service visit for a clear estimate and approval before any repair. Experienced technicians, clear diagnostics, and workmanship coverage on completed repairs.

Book a Repair (310) 554-8899
Service areas

Available in these areas

Get started

Ready to restore your Kenmore appliance?

Book a repair online or call us — clear estimates, approval before any work, and a workmanship warranty on completed repairs.

Book a Repair (310) 554-8899

Book a repair

Tell us about your Kenmore we’ll take it from there

Share your model, symptom, and ZIP in Los Angeles County or Orange County and we’ll confirm an appointment. Prefer to talk? Call us during business hours.

(310) 554-8899
Phone (310) 554-8899
Email info@kenmorelosangeles.support
Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Kenmore appliance repair across Los Angeles County and Orange County.
Response time Appointment timing depends on ZIP code, route capacity, and access.