Skip to content
Appointment timing depends on ZIP code, route capacity, and access.
Call (310) 554-8899
Kenmore appliance service
Error Code

Kenmore Wall Oven F4/E1 Error Code

Plain-language guidance for Kenmore code F4/E1 on Wall Oven — symptoms, safe checks, and when to call a technician.

Book a Repair (310) 554-8899
  • Upfront Estimates
  • Approval Before Repair
  • Expert Technicians
  • Workmanship Warranty

At a glance

Error code overview

A plain-language snapshot of F4/E1 for Kenmore Wall Oven — confirm the model series before you act.

Lena Hart Written by Lena Hart Appliance Repair Content Specialist Published October 20, 2026

Content status Verified

Error code F4/E1
Appliance Wall Oven
Quick answer

Kenmore 665 wall oven code F4/E1: meat probe shorted, with the manual's probe and jack steps.

Model compatibility

Kenmore reuses codes across series and model years, so F4/E1 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Meat probe shorted.

F4/E1 on a Kenmore 665 model wall oven reports a shorted meat probe, listed in the manual as a meat probe malfunction.

Steps the manual gives

  1. Disconnect power or unplug the wall oven.
  2. Unplug the meat probe. Its resistance is measured with a volt/ohm meter (technician work); a reading other than 59000 ohms at room temperature means a new probe.
  3. If the probe is okay, insert it into the jack and check for a firm connection.
  4. Replace the jack if it is damaged or worn out.
  5. Reconnect the wire harness connection on the jack if loose, and replace the harness if damaged.

Related Kenmore wall oven codes

A shorted circuit also shows up in F3/E1, though that one concerns the oven temperature sensor. F3/E0 covers the open-circuit sensor case.

Kenmore oven repair in Los Angeles

Call (310) 554-8899 for wall oven repair in Los Angeles if F4/E1 persists. Have the code, the model number and notes on the meat probe and jack ready.

Source: Kenmore 665 model wall oven error codes

Caution

Safety warning

Important safety warning

Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Get started

Seeing this code on your Kenmore appliance?

Book a specialist Kenmore service visit for a clear estimate and approval before any repair. Experienced technicians, clear diagnostics, and workmanship coverage on completed repairs.

Book a Repair (310) 554-8899
Service areas

Available in these areas

Get started

Ready to restore your Kenmore appliance?

Book a repair online or call us — clear estimates, approval before any work, and a workmanship warranty on completed repairs.

Book a Repair (310) 554-8899

Book a repair

Tell us about your Kenmore we’ll take it from there

Share your model, symptom, and ZIP in Los Angeles County or Orange County and we’ll confirm an appointment. Prefer to talk? Call us during business hours.

(310) 554-8899
Phone (310) 554-8899
Email info@kenmorelosangeles.support
Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Kenmore appliance repair across Los Angeles County and Orange County.
Response time Appointment timing depends on ZIP code, route capacity, and access.