Skip to content
Appointment timing depends on ZIP code, route capacity, and access.
Call (310) 554-8899
Kenmore appliance service
Error Code

Kenmore Range F019 Error Code

Plain-language guidance for Kenmore code F019 on Range — symptoms, safe checks, and when to call a technician.

Book a Repair (310) 554-8899
  • Upfront Estimates
  • Approval Before Repair
  • Expert Technicians
  • Workmanship Warranty

At a glance

Error code overview

A plain-language snapshot of F019 for Kenmore Range — confirm the model series before you act.

Lena Hart Written by Lena Hart Appliance Repair Content Specialist Published October 20, 2026

Content status Verified

Error code F019
Appliance Range
Quick answer

Kenmore range F019: the user interface board cannot configure the relay control board. Reset, harness check, then service.

Model compatibility

Kenmore reuses codes across series and model years, so F019 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

User interface control board is unable to configure the relay control board.

F019 on a Kenmore range means the user interface control board is unable to configure the relay control board. Models: freestanding ranges with 790 model numbers, and Elite electric slide-in ranges 790.4131, 790.4255 and 790.5256.

The manual’s order of steps

  1. Disconnect power to the unit, wait 30 seconds and restore power.
  2. If F019 returns, disconnect electrical power and check the wire harness connections between the user interface control board and the relay control board. Reconnect loose wires or replace a damaged harness.
  3. If you just replaced either board, you may have used the wrong part. Check the part number against your range model number.
  4. With no part replaced and the harness fine, replace the user interface control board.
  5. If the problem continues, replace the relay control board.

The slide-in range names its board the oven user interface control board.

Related codes

  • F018 (relay control board failure)
  • F017 (board cannot configure the touch panel)
  • F022 (communication failure between the interface board and the relay control board)

Kenmore range repair in Los Angeles

Need a hand with your Kenmore range in Los Angeles? Call (310) 554-8899. More is on our range repair service page. Keep the model number and the exact code at hand, plus a note of any resets you tried.

Source: Sears PartsDirect – 790 model 4-digit range error codes; Sears PartsDirect – Elite 790 electric slide-in range 4-digit error codes

Caution

Safety warning

Important safety warning

Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Get started

Seeing this code on your Kenmore appliance?

Book a specialist Kenmore service visit for a clear estimate and approval before any repair. Experienced technicians, clear diagnostics, and workmanship coverage on completed repairs.

Book a Repair (310) 554-8899
Service areas

Available in these areas

Get started

Ready to restore your Kenmore appliance?

Book a repair online or call us — clear estimates, approval before any work, and a workmanship warranty on completed repairs.

Book a Repair (310) 554-8899

Book a repair

Tell us about your Kenmore we’ll take it from there

Share your model, symptom, and ZIP in Los Angeles County or Orange County and we’ll confirm an appointment. Prefer to talk? Call us during business hours.

(310) 554-8899
Phone (310) 554-8899
Email info@kenmorelosangeles.support
Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Kenmore appliance repair across Los Angeles County and Orange County.
Response time Appointment timing depends on ZIP code, route capacity, and access.