Skip to content
Appointment timing depends on ZIP code, route capacity, and access.
Call (310) 554-8899
Kenmore appliance service
Error Code

Kenmore Range F025 Error Code

Plain-language guidance for Kenmore code F025 on Range — symptoms, safe checks, and when to call a technician.

Book a Repair (310) 554-8899
  • Upfront Estimates
  • Approval Before Repair
  • Expert Technicians
  • Workmanship Warranty

At a glance

Error code overview

A plain-language snapshot of F025 for Kenmore Range — confirm the model series before you act.

Lena Hart Written by Lena Hart Appliance Repair Content Specialist Published October 20, 2026

Content status Verified

Error code F025
Appliance Range
Quick answer

Communication between the user interface board and the relay board cannot be initiated. Here is what the owner's manual says to check on a Kenmore range.

Model compatibility

Kenmore reuses codes across series and model years, so F025 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Communication between the user interface board and the relay board cannot be initiated.

F025 tells you that a Kenmore range could not start communication between the user interface board and the relay board. The manual covers it for Kenmore 790 freestanding ranges and, separately, Elite slide-in electric ranges numbered 790.4131, 790.4255 and 790.5256.

What the manual lists

  1. Disconnect power for 30 seconds, then restore it.
  2. Back again? Disconnect electrical power and examine the harness between the user interface control board and the relay control board. Reconnect loose wires, or replace a damaged harness.
  3. If either board was replaced recently, the wrong part may have gone in. Compare the part number against your range model number and fit the right one.
  4. No recent part change and a good harness: replace the relay control board.
  5. Code still present: replace the user interface control board.

The manual groups F025 with F027 under one entry.

Nearby codes

  • F027 shares this entry in the manual.
  • F022 is a communication failure between the same two boards.
  • F019 is the interface board being unable to configure the relay control board.

Kenmore range repair in Los Angeles

Los Angeles owners can reach Kenmore range service at (310) 554-8899. Read out the model number, the F025 code on the display and the steps you have already run through. More detail is on the range repair page.

Source: Kenmore 790 range 4-digit error code reference; Kenmore Elite 790 electric slide-in range error code reference

Caution

Safety warning

Important safety warning

Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Get started

Seeing this code on your Kenmore appliance?

Book a specialist Kenmore service visit for a clear estimate and approval before any repair. Experienced technicians, clear diagnostics, and workmanship coverage on completed repairs.

Book a Repair (310) 554-8899
Service areas

Available in these areas

Get started

Ready to restore your Kenmore appliance?

Book a repair online or call us — clear estimates, approval before any work, and a workmanship warranty on completed repairs.

Book a Repair (310) 554-8899

Book a repair

Tell us about your Kenmore we’ll take it from there

Share your model, symptom, and ZIP in Los Angeles County or Orange County and we’ll confirm an appointment. Prefer to talk? Call us during business hours.

(310) 554-8899
Phone (310) 554-8899
Email info@kenmorelosangeles.support
Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Kenmore appliance repair across Los Angeles County and Orange County.
Response time Appointment timing depends on ZIP code, route capacity, and access.